Operation 12-11 To Dismantle - Perkins New 1000 Series Workshop Manual

12
To dismantle
Special requirements
Special tools
Description
Basic puller
1 Remove the two studs from the pump body.
2 Use a lever under the edge of the pressed steel cover (A1) and remove the cover, there are three recesses
(B1) around the edge of the pump body to give access for a lever. Discard the cover after removal.
3 Remove the impeller (A5) from the pump shaft: Drill four 6.35 mm (0.25 in) holes at equal distance around
the end of the pump shaft, between the shaft and the hub for the impeller. These holes will break the
interference fit between the impeller and the pump shaft and allow removal of the impeller.
1
5
4
A
270
This document has been printed from SPI². Not for Resale
Part number
21825565
2
3
B
A0377
New 1000 Series
Operation 12-11
1
Workshop Manual, TPD 1350E, Issue 4
Continued
A0371