List Of Possible Causes - Perkins New 1000 Series Workshop Manual

9
New 1000 Series

List of possible causes

1 Element of the air filter dirty.
2 Restricted crankcase breather.
3 Element of the air filter not fitted, or not sealing correctly. Loose connection to turbocharger.
4 Internal distortion or restriction in pipe from air filter to turbocharger.
5 Damaged/restricted crossover pipe, turbocharger to intake manifold.
6 Restriction between air filter and turbocharger.
7 Restriction in exhaust system.
8 Turbocharger loose or clamps/setscrews loose.
9 intake manifold has cracks, is loose, or has flange distortion.
10 Exhaust manifold has cracks, is loose, or has flange distortion.
11 Restricted exhaust system.
12 Delay of lubricating oil to turbocharger at engine start.
13 Insufficient lubrication.
14 Dirty lubricating oil.
15 Incorrect lubricating oil.
16 Restricted lubricating oil supply pipe.
17 Restricted lubricating oil drain pipe.
18 Turbine housing damaged or restricted.
19 Leakage from turbocharger seals.
20 Worn turbocharger bearings.
21 Excessive dirt in compressor housing.
22 Excessive carbon behind turbine rotor.
23 Engine speed raised too rapidly at initial start.
24 Insufficient engine idle period.
25 Faulty fuel injection pump.
26 Worn or damaged atomisers.
27 Valves burned.
28 Worn piston rings.
29 Lubricating oil leakage from supply pipe.
30 Excessive preservation fluid (on initial engine start).
31 Excessive engine idle period.
32 Restriction in turbocharger bearing housing.
33 Restriction in lubricating oil filter.
34 Wet type air cleaner: Restricted, dirty element, viscosity of oil to low/high.
35 Waste-gate actuator faulty or damaged.
36 Waste-gate valve not free.
37 Engine stopped too soon from high load.
38 Insufficient lubricating oil.
39 Fuel leakage from fuelled starting aid.
40 Crack in backplate of compressor.
180 Workshop Manual, TPD 1350E, Issue 4
This document has been printed from SPI². Not for Resale