Perkins New 1000 Series Workshop Manual page 171

New 1000 Series
7 Put the bearing (B3) in the recess in the top of the tool with the flat face of the bearing to the bottom of the
recess.
8 Fit the threaded rod (B2) through the bearing and the top of the tool until the handle (B1) is in the recess in
the top of the bearing. In this position adjust the threaded rod until the end is below the bottom of the cylinder
liner. Fit the adaptor (B6) onto the threaded rod and against the bottom of the cylinder liner. Ensure that the
two lugs on the top of the adaptor engage with the flats on the threaded rod. Fit the washer and nut and tighten
the nut onto the adaptor.
9 Lubricate the ratchet of the handle and the threaded rod with a suitable lubricating oil. Operate the handle
and pull the cylinder liner out of the top of the cylinder block.
1
B
Workshop Manual, TPD 1350E, Issue 4
This document has been printed from SPI². Not for Resale
2
3
4
5
6
A0212
7
157