Operation 5-10 To Remove - Perkins New 1000 Series Workshop Manual

5
New 1000 Series
To remove Operation 5-10
1 Drain the lubricating oil and remove the lubricating oil sump, see Operation 10-3.
2 If necessary, remove the balancer unit, see Operation 5-18.
3 If necessary, remove the lubricating oil strainer and suction pipe, see Operation 10-4.
4 Release the setscrews of the centre main bearing and remove the main bearing cap complete with the lower
halves of the thrust washers.
5 Use a suitable tool (A1) made of a soft material to push the upper halves of the thrust washers from their
recesses. Where necessary, move the crankshaft to the front or to the rear to loosen a tight washer.
1
A
A0106
106 Workshop Manual, TPD 1350E, Issue 4
This document has been printed from SPI². Not for Resale