Perkins New 1000 Series Workshop Manual page 337

New 1000 Series
To remove and to fit
Special requirements
Consumable products
Description
POWERPART Silicone rubber
sealant
Warning! Always disconnect the battery terminals before the removal of any component of the electrical
system.
To remove
If the engine has a flywheel housing which is oil filled, drain the flywheel housing before the starter motor is
removed.
1 Disconnect the battery.
2 Disconnect the starter motor cables.
3 Release the fasteners and remove the starter motor and the distance piece, if one is fitted.
To fit
Note: Some starter motors may have an "O" ring fitted to the starter motor flange. If an "O" ring is fitted ensure
that a new "O" ring is fitted.
1 Clean the flange face of the starter motor, the distance piece, if one is fitted, and the face of the flywheel
housing.
If the engine has a flywheel housing which is oil filled, the starter motor must be sealed before it is fitted. Apply
a 2,0 mm (0.080 in) continuous bead of POWERPART Silicone rubber sealant to the flange face of the starter
motor (A2) and to the flywheel housing (A3).
Caution: For engines fitted with a distance piece: Do not fit the starter motor without the distance piece.
2 If one is fitted, ensure that the distance piece (A4) is fitted in position, with its location lip to the flywheel
housing, and that the cap screws (A5) are tight.
3 Fit the starter motor and tighten the fasteners.
4 Connect the starter motor cables.
5 Connect the battery.
1
2
A
Workshop Manual, TPD 1350E, Issue 4
This document has been printed from SPI². Not for Resale
Part number
1861108
4
5
3
A0150
14
Operation 14-7
323