Perkins New 1000 Series Workshop Manual page 326

13
New 1000 Series
Ring gear
To remove and to fit Operation 13-2
To remove
Warning! Wear eye protection during this operation.
Before the ring gear is removed, check the position of the chamfer on the teeth.To remove the ring gear use
a hammer and a chisel to break the ring. Ensure that the flywheel is not damaged during this operation.
To fit
The ring gear is heated onto the flywheel. When a new gear is to be fitted, ensure that it is not heated to more
than 250 °C (480 °F). Ensure that the chamfer on the teeth of the gear is in the correct direction.
312 Workshop Manual, TPD 1350E, Issue 4
This document has been printed from SPI². Not for Resale