12
New 1000 Series
To fit (four cylinder turbocharged engines)
Operation 12-22
1 Renew the "O" rings on the inlet connection for the coolant (A3) and the outlet flange for the coolant (A5).
Ensure that the joint faces are clean. Renew the joint (A4) for the oil pipe flange.
2 Lightly lubricate the bore of the vent connection (A2) and the "O" ring on the coolant inlet connection with
clean engine lubricating oil.
3 Loosely fit the hose clip to the vent connection.
4 Fit the cooler to the engine with the vent (A1) fitted correctly in its connection. Tighten the setscrews and the
hose clip of the vent connection.
5 Fit and tighten the setscrew of the support bracket.
6 Fit the setscrew and nut which fasten the low-pressure fuel pipes to the top of the oil cooler.
7 Fill the coolant system.
8 Operate the engine and check for leakage of coolant or oil.
2
1
3
4
5
A
A0273
292
Workshop Manual, TPD 1350E, Issue 4
This document has been printed from SPI². Not for Resale