Inspect For Damage And Loose Or Missing Parts; Check The Hydraulic Oil Level - Genie Z-25/8 Service Manual

First Edition • Third Printing
A-3
Inspect for Damage and Loose or
Missing Parts
Daily machine condition inspections are essential
to safe machine operation and good machine
performance. Failure to locate and repair damage,
and discover loose or missing parts may result in
an unsafe operating condition.
1 Inspect the entire machine for damage and
improperly installed or missing parts including:
· Electrical components, wiring and electrical
cables
· Hydraulic power units, hoses, fittings,
cylinders and manifolds
· Drive motors
· Boom components and wear pads
· Dents or damage to machine
· Tires and wheels
· Limit switch, alarms and horn
· Beacon and alarms (if equipped)
· Nuts, bolts and other fasteners
· Platform entry mid-rail/gate
· Brake release components
· Slide-out component tray
· Battery pack connections
Part No. 41314 Genie Z-20/8N & Genie Z-20/8 & Genie Z-25/8
Section 4 • Scheduled Maintenance Procedures
TABLE A PROCEDURES
A-4

Check the Hydraulic Oil Level

Maintaining the hydraulic oil at the proper level is
essential to machine operation. Improper hydraulic
oil levels can damage hydraulic components. Daily
checks allow the inspector to identify changes in oil
level that might indicate the presence of hydraulic
system problems.
Z-25/8 before serial number 212
Z-20/8 before serial number 122
Z-20/8N before serial number 896:
1 Be sure that the boom is in the stowed position.
2 Pull the hydraulic component tray out and
visually inspect the oil level in the tank.
Result: The hydraulic oil level should be within
2 inches (5 cm) of the
Z-25/8 after serial number 211
Z-20/8 after serial number 121
Z-20/8N after serial number 895:
1 Raise the boom approximately 1 foot (30 mm).
2 Remove the mounting fasteners to the hydraulic
access panel located under the boom linkage at
the center of the chassis. Remove the panel.
mark on the tank.
FULL
4 - 3