JRC JLR-7500 Instruction Manual page 7

Hide thumbs Also See for JLR-7500:
Table of Contents

Advertisement

When connecting the cable attached to the equipment, do not bend it acutely, twist
it, or impart excessive force. Doing so sometimes causes cracks or damage to the
coating, resulting in fire or electrocution.
Do not install the sensor where there is excessive vibration.
Vibration may cause sensor failure.
Do not paint the sensor.
Doing so may result in reception problems.
The junction box rubber gaskets (φ 25 Gland side) fit φ 10 - 20 cables.
Install the sensor where there are no obstacles, in order to ensure that GPS signals
can be directly received from satellites without interference or reflection of signals
from surrounding objects.
Whenever possible, select a place with the following characteristics.
1.
An open space, which allows uniform reception of satellite signals.
2.
Far away from any high power transmission antennas.
3.
Outside radar beams.
4.
Away from the INMARSAT antenna by at least 5 meters and outside
the INMARSAT beam.
5.
Away from the antenna of a VHF transmitter and a direction finder
by at least 3 meters.
6.
Away from a Magnetic Compass by at least 1 meter.
7.
3 meters or more away from amateur radio antennas.
If it is difficult to find an ideal site, select a place temporarily and install the equipment. Conduct a
test to make sure that the proper performance can be obtained and then fix the equipment in
position. If it is installed at an improper place, reception accuracy may be impaired.
CAUTION
v

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jlr-7800Nwz-4740

Table of Contents