Starting Navigation With The Goto Key - JRC JLR-7500 Instruction Manual

4.6.2

Starting Navigation with the GOTO Key

· If a waypoint or route is selected with the GOTO key, navigation starts to that waypoint.
· If a waypoint on the active route is selected with the GOTO key, navigation restarts from that
waypoint.
· Routes created with GOTO are stored as a temporary route with route number 102.
· The GOTO key can be used from any screen other than the menu screen, waypoint
information screen, or Navigation Assistance 4 screen.
· The following methods can be used to select the waypoint.
(1) Set HOME PORT as the waypoint.
(2) Enter the waypoint number.
(3) Enter the route number.
(4) Enter the event / mark number.
(5) Set the cursor position as the waypoint (Up to 512 waypoints can be set, allowing temporary
route creation)
(6) Select from each list (waypoint list, route list, event / mark list).
(7) Enter the waypoint number on the active route to restart the navigation.
Procedure
(1) Set HOME PORT as the waypoint
HOME sets the HOME PORT registered at the start of they waypoint list as the waypoint. If a
waypoint is set as HOME, it can be easily set as a waypoint.
If no HOME PORT is registered, "1. HOME" will not be displayed.
1. Press and then
Navigation will start with the HOME PORT as the destination waypoint.
(2) Enter the waypoint number
If you know the waypoint number, you can enter the number to set the waypoint.
1. Press and then
2. Enter the waypoint number, and press
4-56
.
.
to start navigation.
Set HOME as waypoint
Enter waypoint number
Enter route number
Enter event / mark number
Display plot screen
Display waypoint list
Display event / mark list
Display route list