Copying Waypoint Information - JRC JLR-7500 Instruction Manual

Hide thumbs Also See for JLR-7500:
Table of Contents

Advertisement

4.4.5

Copying Waypoint Information

· Waypoint information can be copied to another waypoint number. Event and mark information
can also be copied to the waypoint list. HOME is treated as number 1 on the waypoint list.
· The waypoints used by the shared active routes received from ECDIS, which are stored in
number 10001 - 10512, are automatically overwritten when the next route is received.
Waypoints which you wish to retain must be copied to a number between 1 and 10000.
· The temporary route waypoints stored in numbers 10513 to 11024 disappear when a different
temporary route is created or the power is turned off. Waypoints which you wish to retain must
be copied to a number between 1 and 10000.
· When there is no more space available, entries can be overwritten. However, waypoints used
by a route cannot be overwritten.
· Select the source to copy from, and specify the number to which the information is to be
copied.
Procedure
1.
Press
,
2.
Press
"WPT COPY".
3.
The cursor will move to the "COPY ORG", so press
4.
Press
The following is an overview of the copy source submenu.
(1) WPT LIST:
(2) EVENT LIST:
(3) WPT No:
(4) FROM TO:
(1) When "WPT LIST" is Selected
The range to be copied is confirmed when
point.
Please refer to "4.8.3 Selecting a Range within a List" for details regarding range selection.
(2) When "EVENT LIST" is Selected
The range to be copied is confirmed when
point.
Please refer to "4.8.3 Selecting a Range within a List" for details regarding range selection.
4-36
, and then
, and display the waypoint/route copy screen.
to select the copy source, and then press
From the waypoint list, choose 1 waypoint number, or a string of
contiguous waypoint numbers.
Any number can be selected, from 1 to 11024.
From the event/mark list, choose 1 event/mark number, or a string of
contiguous event/mark numbers.
Use the numeric keypad to enter the waypoint number.
Use the numeric keypad to enter the start and end numbers from the
waypoint list.
.
.
is pressed after selecting the start and end
is pressed after selecting the start and end

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jlr-7800Nwz-4740

Table of Contents