Table of Contents
Advertisement
6.2 Display Unit Installation
6.2.1
Selecting the Position for Installation
Install this unit at least 1 m away from any magnetic compasses.
Installation near a magnetic compass may result in interference with the
magnetic compass, and may result in an accident.
Use the indicated screws when installing the display unit to a stable wooden
surface. Failure to do so may result in the display unit falling over, causing injury
or property damage.
The installation stand (trestle) allows this display to be set up on table-tops, walls, ceilings, etc.
Select an installation location that meets the following conditions.
6.2.2
Display Installation Procedure
Mount the unit as described below.
(1) Loosen the unit knob, and disconnect the mount from the unit.
(2) Use the included screws to secure the mount where desired.
(3) Return the unit to the mount, and tighten it with the knob.
6-6
Warning
Caution
370 or more
Mount (Bottom)
201 or more
Mount
Knob Bolt
(Unit: mm)
Advertisement
Table of Contents
