Download Print this page

JRC JLR-7500 Instruction Manual: Setting Beacon/sbas

Hide thumbs

Advertisement

4.16.8 Setting Beacon/SBAS

Beacon and SBAS settings can be performed.
The sensor must support SBAS to perform SBAS settings.
· The submenus on the beacon/SBAS settings screen are as follow.
(1) STATION SELECT:
AUTO:
MANUAL:
(2) FREQUENCY:
(3) BIT RATE:
(4) BEACON INFORMATION: Set to "ON" to display received beacon information.
(5) SBAS SEARCH:
AUTO:
MANUAL:
(6) TYPE 0 INFORMATION: Set whether test broadcast data is used.
ON:
OFF:
(7) RANGING:
ON:
OFF:
· Please refer to "4.20 Equipment Configuration" and switch the unit to equipment configuration
mode.
Procedure
1.
Press
,
(1) Setting Beacon station
2.
Press
"STATION SELECT".
3.
Press
If set to Manual, "2. FREQUENCY" and "3. BIT RATE" can be selected.
Press
"FREQUENCY".
Enter the frequency with the numeric keypad, and press
Press
"BIT RATE".
Press
(2) Setting Beacon Information
Refer to "4.13 Beacon Information".
Set the beacon station selection method.
The best beacon station is selected automatically from the GPS
position.
You can set the frequency and bit rate manually.
Set the frequency when station selection is set to manual.
Set the bit rate when station selection is set to manual.
The SBAS satellite can be set.
The SBAS satellite is automatically set.
The SBAS satellite number is set manually.
Used.
Not used. (default)
You can set whether SBAS satellite information are used like
GPS satellites in positioning.
Used.
Not used. (default)
, and then
to select the method, and press
to select the bit rate, and press
to display the Beacon/SBAS setting screen.
.
.
.
4-93

Advertisement

   Also See for JRC JLR-7500

   Related Manuals for JRC JLR-7500

This manual also for:

Jlr-7800, Nwz-4740

Comments to this Manuals

Symbols: 0
Latest comments: