Setting Lan Settings - JRC JLR-7500 Instruction Manual

Hide thumbs Also See for JLR-7500:
Table of Contents

Advertisement

4.20.7.7 Setting LAN Settings

· LAN configuration can be performed for active route sharing, data route sharing, data output,
mutual monitoring, and remote maintenance output.
· In data output, the output NMEA sentence can be selected.
· To share active or data routes, sharing route configuration must be performed.
Set the route sharing setting to "SHARE" for data routes.
When set to "SHARE", data route reception will occur automatically.
For active routes, set the route sharing setting to "SHARE 1", "SHARE 2", "SHARE 3", or
"SHARE 4".
(1) SHARE1:
(2) SHARE2:
(3) SHARE3:
(4) SHARE4:
The following icon is displayed when active routes are shared.
SHARE1 Icon:
· To perform mutual monitoring, mutual monitoring mode must be configured. With mutual
monitoring mode, when GPS positioning is not being performed, the GPS positioning
information from other units can be displayed.
· Remote maintenance output configuration can be used to regularly output data for use in
remote maintenance.
If the active route is switched on the unit, the route will automatically be sent
out to connected equipment.
When a shared route is received, the route is automatically switched.
If the active route is switched on the unit, a request is made to the user of
the unit before the route is sent. Transmission of the route to the connected
equipment is dependant on the permission of the user.
If the user has not authorized sending, the active route will only be executed
on the local unit.
When a shared route is received, the route is automatically switched.
If the active route is switched on the unit, the route will automatically be sent
out to connected equipment.
When a shared route is received, the user is asked whether or not they want
to switch routes.
If the user does not authorize route switching, the route will not be switched.
If the active route is switched on the unit, a request is made to the user of
the unit before the route is sent. Transmission of the route to the connected
equipment is dependant on the permission of the user.
If the user has not authorized sending, the active route will only be executed
on the local unit.
When a shared route is received, the user is asked whether or not they want
to switch routes.
If the user does not authorize route switching, the route will not be switched.
SHARE2 Icon:
LAN Selection Screen
SHARE3 Icon:
LAN setting pull-down
Data output setting
ACTIVE route sharing setting
DATA route sharing setting
Mutual monitoring mode setting
Remote maintenance output setting
SHARE4 Icon:
4-113

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jlr-7800Nwz-4740

Table of Contents