Setting Data Out2; Setting Data Out3; Setting Data In/Out4 - JRC JLR-7500 Instruction Manual

Hide thumbs Also See for JLR-7500:
Table of Contents

Advertisement

4.20.7.2 Setting Data OUT2

· NMEA, JRC, IEC, route WPT, and automatic switch control data can be output via data OUT2.
Procedure
1.
Please refer to "4.20 Equipment Configuration" and switch the unit to equipment
configuration mode.
2.
Press
, and then
From this point on, operation is identical as that described for "DATA IN/OUT1".
However, routes and waypoints can not be received from external sources as RTE and WPL
sentences.

4.20.7.3 Setting Data OUT3

· NMEA, JRC, IEC, route WPT, and automatic switch control data can be output via data OUT3.
Procedure
1.
Please refer to "4.20 Equipment Configuration" and switch the unit to equipment
configuration mode.
2.
Press
, and then
From this point on, operation is identical as that described for "DATA IN/OUT1".
However, routes and waypoints can not be received from external sources as RTE and WPL
sentences.

4.20.7.4 Setting Data IN/OUT4

· NMEA, JRC, IEC, route, and switch data can be output via data IN/OUT4.
・ To connect Current, temperature and Depth meter, set to only bit rate and use a Pin No.1,2 in
DATA IN/OUT connector.
· The layer and data number for displaying tidal current data can be set by setting externally
connected equipment. Please refer to "4.20.7.8 Setting Tidal Current Meter Input" for setting
method.
Procedure
1.
Please refer to "4.20 Equipment Configuration" and switch the unit to equipment
configuration mode.
2.
Press
, and then
From this point on, operation is identical as that described for "DATA IN/OUT1".
to select "DATA OUT2".
to select "DATA OUT3".
to select "DATA IN/OUT4".
4-111

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jlr-7800Nwz-4740

Table of Contents