6.1.4 Installation of the Sensor to pass a cable through a pole
It is possible to pass a cable through a pole, when DGPS sensor attached to poles with cut male
screws. (1inch-14 UNS-2A). In this case, Cable guard rubber (attached article) used.
(1) The cable is installed as following figure.
Do not bend the cable acutely. Doing so may result in damage to the cable.
Do not bend it acutely
(2) Cable guard rubber is set in DGPS sensor.
6-4
Cable guard rubber
(attached article )
Cable installation figure
Push all the way in