Table of Contents
Advertisement
8.
Press "START" to display the following, and press "YES" to start data output.
(4) Selecting "ROUTE" and receiving data
Routes and waypoints are received from external sources as RTE and WPL sentences.
Select the bit rate.
3.
Press "DATA IN/OUT".
4.
Press
5.
Press "BITRATE", and select the bit rate.
6.
Press "START" to display the following, and press "YES" to enter data receiving
mode.
7.
Once the unit is awaiting data reception, send RTE or WPL sentences from externally
connected equipment.
Received data is stored in the internal memory.
8.
When all data transmission has been completed, press
The unit will continue awaiting data until
YES
to select "IN", and then press
YES
.
.
is pressed.
4-109
Advertisement
Table of Contents
