Installation Of The Sensor On The Mast - JRC JLR-7500 Instruction Manual

Hide thumbs Also See for JLR-7500:
Table of Contents

Advertisement

6.1.3

Installation of the Sensor on the Mast

Use a screw adapter (optional component or equivalent) to connect the sensor to the mast.
The diagram shows the JLR-4341, but these instructions apply equally to the JLR-4340 as well.
Fitting Belt
MPBP02520
1. Loosen the fitting belt screw
with a screwdriver to remove
the clamp.
Clamp
Flathead Screwdriver
Mast (φ26 to φ90 supported)
2. Coil the fitting belt around
the mast as shown below.
How to Install the Sensor on the Mast
JLR-4341
DGPS Sensor
Screw Adapter
MTV302007A
Clamp Band
3. Tighten the clamp screw with
the screwdriver.
6-3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jlr-7800Nwz-4740

Table of Contents