(3) Data output setting
3.
Press
4.
Press
"CONNECT".
5.
Select the connection destination with
"MULTICAST", "UNICAST", or "BROADCAST" can be set as connection destinations.
Normally, "MULTICAST" should be selected.
When "UNICAST" is selected, destination IP "2. To IP" and "3. Port No." can be set.
6.
Press
"FORMAT".
7.
Press
, select the data format, and press
"IEC", "NMEA Ver1.5", "NMEA Ver2.1", and "NMEA Ver2.3" can be chosen as data formats.
8.
Press
"SENTENCE".
9.
Press
10. Press
11. After you have selected all sentences you wish to output, press
(4) Mutual monitoring mode setting
3.
Select "MUTUAL" with
4.
Press
To stop mutual monitoring, select "OFF".
When "ON" is selected, and select "CONNECT". Normally, "MULTICAST" should be
selected.
to select "DATA OUT", and press
to select the output sentence, and press
to select the sentence output interval, and press
, and press
to select "ON", and then press
.
, and press
.
.
.
.
.
.
.
4-115