Table of Contents
Advertisement
4.20.7.1 Configuring Data IN/OUT1
· NMEA, JRC, IEC, route WPT, automatic switch control data, and printer data can be output via
data IN/OUT1.
· To connect a DPU-414 printer, use a D-sub9 pin connector.
Procedure
1.
Refer to "4.20 Equipment Configuration" and display the equipment configuration menu.
2.
Press
, and then
3.
Select the data type with
(1) When "NMEA" is Selected
Select the version, bit rate, output sentence, and interval.
The selected sentence is displayed.
If no sentence has been selected, no
sentence is
If no sentence is displayed, the output sentence has not been selected.
4.
Press "SENTENCE".
5.
Move the cursor to the sentence you wish to output, and press
6.
The output interval is displayed. Select the interval and press
4-106
, and select "DATA IN/OUT1".
and press
displayed.
.
Sentence and Interval Setting Screen
.
.
Advertisement
Table of Contents
