Download  Print this page

JRC JLR-7500 Instruction Manual: Line Display; Drawing Lines

Hide thumbs

Advertisement

4.3.10 Line Display

· Lines can be drawn between any two points on the plot screen.
· To turn off line display, set "LINE" to "OFF" as described in "4.3.12 Hiding Plot Screen
Symbols".

4.3.10.1 Drawing Lines

The cursor is used to set start and end points on the plot screen, and a line is drawn connecting
them.
Line start and end points can be registered as marks in the event/mark list.
If
is pressed before an end point is selected, the previous inflection point is deleted.
Procedure
1.
Press
, and display the cursor.
2.
Press
3.
Press
4.
At the same position as the end point, press
If steps 2 and 3 are repeated before step 4, a line will be drawn using the end point as an
inflection point.
①Move the cursor to the start point
and press the ENT key.
②Move the cursor to the
inflection point and press the
ENT key.
to move the cursor to the start point, and press
to move the cursor to the end point, and press
again.
③Move the cursor to the
inflection point and press
the ENT key.
④Move the cursor to the
end point and press the ENT
key twice.
.
.
4-25

Advertisement

   Also See for JRC JLR-7500

   Related Manuals for JRC JLR-7500

This manual also for:

Jlr-7800Nwz-4740

Comments to this Manuals

Symbols: 0
Latest comments: