JRC JLR-7500 Instruction Manual page 101

(3) Select a route number
If you know the route number, you can enter the number to set the route.
1. Press and then
2. Enter the route number, and press
3. The route start / end screen will be displayed, so perform route settings.
Please refer to "4.6.1 Selecting a Route from the Route List" for details regarding each
submenu and configuration methods.
4. Press "NAVIGATION" to start navigation.
(4) Select from the event / mark number
If you know the event / mark number, you can enter the number to set the waypoint.
1. Press and then
2. Enter the event / mark number, and press
(5) Set the cursor position as the waypoint
Any cursor position on the plot screen can be set as waypoints. Multiple waypoints can be
selected and a temporary route created. Temporary routes can also be added to the route
list as a permanent route.
1. Press , and then
2. Move the cursor to the waypoint position, and press
For multiple waypoints, move the cursor again, and press
Pressing
At point you wish to make waypoint,
press
3. Press again at the final waypoint to start navigation.
4. The following will be displayed.
.
.
, and display the plot screen.
deletes the previous waypoint.
.
to start navigation.
.
Move cursor
At point you wish to make waypoint,
press
.
twice.
4-57