Sharing Routes With Ecdis; Sharing Data Routes - JRC JLR-7500 Instruction Manual

(3) When "ROUTE No." is Selected
Enter the route number with the numeric keypad, and press
4. Press
The following is an overview of the waypoint deletion submenu.
(1) ROUTE:
(2) ROUTE + WPT:
(3) CANCEL:
5. The following will be displayed. Press
4.5.6

Sharing Routes with ECDIS

This unit can be used to send routes to ECDIS or radars, and also to receive routes created by
ECDIS (data route sharing). Routes which are underway (active routes) can be shared.
If a route is switched on this unit or on ECDIS when sharing the active route, the connecting
equipment's route will also switch.
In order to share routes, the equipment must support sharing (ECDIS, radar), and be connected
in a LAN.
4.5.6.1

Sharing Data Routes

This unit can be used to send routes to ECDIS, and also to receive routes created by ECDIS. If
data route sharing is configured, data route reception will occur automatically.
First, configure data route sharing.
If data routes are not shared, configure sharing as directed in "4.20.7.7 Setting LAN Settings ".
To send a data route, follow the procedures below to select and send the desired route.
Procedure
1. Press ,
2. Press "OUT / IN".
3. Press
4. Press "CONNECT".
5. Select the connection destination with
Normally, "MULTICAST" should be selected for the destination.
To send to a specific unit, select "UNICAST".
to select whether the waypoint is deleted, and the press
Only the route is deleted.
The route as well as the waypoint used on the route are deleted.
The waypoint used on the different route is not deleted.
Deleting is cancelled.
, and , and select "TRANSFER WPT / ROUTE (LAN)".
to select "OUT", and then press
to select "YES", and press
Delete Range Start Point
Delete Range End Point
Items to be Deleted
.
, and press
.
.
.
.
4-49