Setting Contact Output 1; Setting Contact Output 2 - JRC JLR-7500 Instruction Manual

4.20.7.5 Setting Contact Output 1

· The following contact outputs can be set for contact output 1: System, System + XTD + ARV,
Log Pulse (200 pulse/NM), Log Pulse (400 pulse/NM), and Alarm ACK.
· Please refer to "6.3 Cable Connection" for connection.
The following is an overview of the contact output 1 submenu.
· SYSTEM:
· SYS+XTD+ARV: A contact is made when No positioning fixing, XTD / boundary, or arrival /
· 200p/NM:
· 400p/NM:
· ALARM ACK:
Procedure
1. Please refer to "4.20 Equipment Configuration" and switch the unit to equipment
configuration mode.
2. Press , and then
3. Select the state for which you want contact operation with
.

4.20.7.6 Setting Contact Output 2

· The following contact outputs can be set for contact output 2: System, System + XTD + ARV,
Log Pulse (200 pulse/NM), Log Pulse (400 pulse/NM), and Alarm ACK.
· Please refer to "6.3 Cable Connection" for connection.
1. Please refer to "4.20 Equipment Configuration" and switch the unit to equipment
configuration mode.
2. Press , and then
From this point on, operation is identical as that described for "CONTACT OUT1".
4-112
A contact is made when the No positioning fixing alarm occurs.
anchor alarms occur.
200 pulse/NM LOG pulse is output.
400 pulse/NM LOG pulse is output.
Operates as an ACK when an alarm has been generated by externally
connected equipment.
to select "CONTACT OUT1".
to select "CONTACT OUT2".
, and then press