Alpha Descriptor Programming; About Alpha Descriptor Programming; Assigning Zone Descriptors - ADEMCO Vista-10SEa Installation And Setup Manual

Vista-10sea

Hide thumbs Also See for Vista-10SEa:

User manual (40 pages)

User manual (40 pages)

Table Of Contents

100

Table of Contents

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

In This Section

About Alpha Descriptor Programming

Assigning Zone Descriptors

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

About Alpha Descriptor Programming

This section provides instructions for programming alpha descriptors. This is recommended

for systems using alpha keypads, and necessary if the system is using a 4285/4286 Phone

Module. Alpha descriptors cannot be displayed on fixed-word keypads.

If the system is using a 4285/4286 Phone Module, select only from those words in the

"Alpha Vocabulary List" shown in boldface type (on a following page). The phone module

will not provide annunciation of other words.

If a 4285/4286 Phone Module is added to an existing V10SEa system, reprogram the alpha

descriptors presently in the system, selecting from those words shown in boldface type in the

Alpha Vocabulary List. The phone module will not provide annunciation of any other words.

Assigning Zone Descriptors

The

alpha

English-language descriptor/location of all protection zones, keypad Panics, and RF

receiver/relay or zone expander supervision faults programmed into the system. Each

descriptor can be comprised of a combination of words (up to 3) selected from a vocabulary

of words stored in memory (the list is on a following page). In addition, you can add up to

5 installer-defined words to those already in memory. Thus, when an alarm or trouble

occurs in a zone, an appropriate descriptor for that zone's location will be displayed at the

keypad.

NOTE: You can enter alpha descriptors locally at the alpha keypad or remotely using

Entering Zone Descriptors (in Program Menu Mode 82)

You can enter the descriptor when the zone is being defined in field 56.

Alternatively, you can enter zone descriptors in field

The procedure simply requires that you enter the 3-digit reference number for the desired

word(s). The 3-digit number for each word is provided in the "Alpha Vocabulary List" on a

following page.

Programming the Descriptors

1. With the system powered up, enter the Programming mode by keying:

Installer code (4 1 1 1) + 8 + 0.

The following display will appear:

Installer Code