Programming The Rf Transmitters (5800 Rf Systems); Enrolling 5800 Transmitters Into The System; Enrolling Through Zone Programming - ADEMCO Vista-10SEa Installation And Setup Manual

Model Product
5890, PIR Detector
5890PI
5899 Magnets

Programming the RF Transmitters (5800 RF Systems)

1. With at least one 2-line alpha keypad connected to the keypad terminals, power up the
system temporarily. If you previously connected the AC plugpack to the control panel,
you need only plug the plugpack in (to 230VAC outlet) to power up the system.
2. Enter the programming mode by keying: Installer Code + 8 + 0.
Data field 22 RF SYSTEM TYPE must have been programmed for a 5800 RF system before
continuing ("2" entered in that field).
3. 24 RF HOUSE ID CODE. The House ID identifies a 5827 or 5827BD Wireless Keypad
if it is used (enter 01–31). The wireless keypads should be set to the same ID. If no
wireless keypad is to be used, leave as "00."

Enrolling 5800 Transmitters into the System

There are two methods to enroll transmitters. The first is performed in
programming mode, which is described in this section. In
transmitter into the system as you are entering the zone information.
The second method is called "sequential mode," and uses
SEQUENTIAL MODE). In 83 mode, you enroll all the transmitters into the system after all
zone information has been entered.
As an option, the zone programming and sequential modes allow you to use a 5804 button-
type transmitter as a "program tool." The advantage of using a program tool is that it tells
the control that you are about to enroll a transmitter into the system. You can move to the
physical location of the transmitter to be enrolled, press the upper left-hand button of the
program tool, and then trip the intended transmitter (see step 10 for operation). This helps to
prevent random signals from being accepted into the system until you are ready to enroll the
intended transmitter.
The transmitter that you use as the program tool can also be used as a transmitter in the
system. If you plan to use an existing transmitter, you must first enroll it into the system as
its associated zones. You may then program it as the tool.

Enrolling Through Zone Programming ( 56)

1. Enter Programming mode [Installer Code] + 8 + 0.
Enter Zone Programming by pressing 56. If the system has been set up to use 5800 Series
RF, and a program tool has been entered, skip to step 4. If no program tool has been entered,
the following prompt will appear:
Program Tool?
0 = No, 1 = Yes 0
Compatible 5800 Series Transmitters Table (Continued)
Enter as Input
Device Type
2. If you are using a program tool, enter "1." If not, enter
Section 6: Wireless (RF) Zone Expansion
Description
Dual-element passive infrared detector/transmitter
RF
with selectable pulse count. PI version has 20Kg
pet immunity.
NOTE: There is a 3-minute lockout between fault
transmissions to conserve battery life.
Package of 4 magnets for use with 5816 and 5817
transmitters.
"0" and skip to Step 4.
56 zone
56 mode, you enroll each
83 (described in Section 12:
6-7