ADEMCO Vista-10SEa Installation And Setup Manual page 44

VISTA-10SEa Installation and Setup Guide
strength and reorient or relocate transmitters if necessary.
During this mode, wireless receiver gain is reduced by 50%. Testing in this mode assists in
determining good mounting locations for the transmitters, and verifies that the RF
transmission has sufficient signal amplitude margin for the installed system.
1. Enter the Installer Code + # + 4.
2. Once transmitters are placed in their desired locations and the approximate length of
wire to be run to sensors is connected to the transmitter's screw terminals, fault each
transmitter. Do not conduct this test with your hand wrapped around the transmitter, as
this will cause inaccurate results.
•
•
3. Mount the transmitter according to the instructions provided with the transmitter.
4. Exit the Go/No Go test mode by entering Installer Code + (OFF).
6-12
The keypad will beep three times to indicate signal reception.
If the keypad does not beep, re-orient or move the transmitter to another location.
Usually a few centimeters in either direction is all that is required.