Wireless Systems Available; Wireless System Receivers Table; Wireless System Operation And Transmitter Supervision - ADEMCO Vista-10SEa Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section

Wireless Systems Available

Wireless System Operation and Transmitter
Supervision
Receiver Supervision
Wireless System Installation Advisories
Installation and Setup of the 5881
Wireless Receivers
Installing the 5800TM Module
5800 Series Transmitter Setup
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Wireless Systems Available
The VISTA-10SEa supports wireless zones that may be used exclusively, or in addition to the
basic wired zones 1 through 6.
The following receivers may be used with this system. Each supports the number of zones
shown:
Any zone number from 10–63 can be used as a 5800 Series wireless zone (do not confuse this
with the number of zones that can be used, which is shown in the Wireless System Receivers
Table above).

Wireless System Operation and Transmitter Supervision

The receiver responds to status and alarm signals from wireless transmitters (operating at
345MHz for 5800 Series, within a nominal range of 60m); the receiver then relays this
information to the control.
Wireless (RF) Zone Expansion

Wireless System Receivers Table

5800 Series
Receiver Wireless Zones
5881L
5881M
5881H
Programming the RF Transmitters (5800 RF
Systems)
Enrolling 5800 Transmitters into the System
Enrolling Through Zone Programming
Removing a Zone from the System (5800 System)
Deleting a Transmitter Serial Number from a
Zone in *56 Mode
Checkout Procedure for Wireless Zones
up to 8
up to 16
up to 16
S E C T I O N
(5800 RF Systems)
6
6-1