Checking The Operation Of The 4285/4286 Phone Module - ADEMCO Vista-10SEa Installation And Setup Manual

alarm, trouble, etc. (the phone module will annunciate zone numbers only).
You can enter zone descriptors now, using Interactive mode 82, or later. See Section 11:
ALPHA DESCRIPTOR PROGRAMMING for a detailed procedure.
6. Exit the Programming mode by entering 99. Perform a preliminary check of the 4285
Phone Module, as indicated next.

Checking the Operation of the 4285/4286 Phone Module

To Check Phone Module Operation from an On-Premises Phone
1. Pick up the phone and enter the programmed 2-digit Phone code (entered in field 26,
VOICE MODULE ACCESS CODE). Annunciation of a system status report should
automatically start. See the User's Guide accompanying the phone module for detailed
information regarding the nature of the status report, if necessary.
2. During any pause in the status report, or immediately following it, key the following via
the keypad on the phone:
Installer code (4111) +1 (OFF)
3. You should hear a beep on the phone and from a wired keypad, and the words
"DISARMED...READY TO ARM" or "DISARMED...NOT READY TO ARM"*
indicating that you entered the command successfully.
* "DISARMED...NOT READY TO ARM" would indicate an open zone.
4. Hang up the phone.
To Check Phone Module Operation from an Off-Premises Phone
1. Have someone dial the premises phone number, using a multifrequency DTMF phone.
•
•
NOTE: If you entered 15 in field 95 to bypass an answering machine, and a 4285/4286
2. When the caller enters the 2-digit phone code, he will hear a voice prompt asking for
entry of the 4-digit system code ("ENTER SYSTEM CODE NOW").
3. The caller should then enter the Installer code (4111). As a safety feature, there is a 3-try
limit in which to enter each code (Phone code and System code), after which the call-in
will be aborted. Also, if the caller presses no keys for 20 seconds, the call-in will be
aborted.
4. A system status report will begin annunciation if both codes were entered correctly.
5. During any pause in the status report, or immediately following it, the caller should key
the following via the keypad on the phone:
Installer Code (4111) + 1 (OFF)
6. A wired keypad on the premises should now beep. Also, the caller should hear a beep on
his phone, and the words "DISARMED...READY TO ARM" or "DISARMED...NOT
READY TO ARM"*, indicating that the command was entered successfully.
7. At this point, the caller can hang up the phone.
8. Verify with the caller that there was successful access to the system and that the
appropriate annunciations were heard on the phone.
If the phone system does not include an answering machine, the caller will hear 2
long tones in the phone, followed by the voice prompt, "HELLO, ENTER PHONE
CODE NOW." The caller should then enter the programmed 2-digit Phone code
(entered in field 26 VOICE MODULE ACCESS CODE).
If the premises phone system includes an answering machine, the caller should enter
the 2-digit Phone code during a pause at the beginning of, or during, the outgoing
answering machine message.
Phone Module is included in the installation, off-premises phone operation will be
affected. Read the "Important Note" in the programming information for field 95
on the previous page.
*"DISARMED...NOT READY TO ARM" would indicate an open zone
Section 8: 4285/4286 Phone Voice Module
8-5