Troubleshooting Guide; System (Including Wireless) - ADEMCO Vista-10SEa Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section

System (including Wireless)

Control
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
SYMPTOM
1. Transmitter signal not
received at 5881.
2. Transmitter zone number
appears during Transmitter
Sniffer mode, but does not
clear.
3a. "Bat" or "System Lo Bat"
(with no zone no.
displayed).
3b. "Bat" + "00" (fixed-word
keypad display) or "KYPD
LB" + "00" (alpha keypad
display).
3c. "Bat" or "Lo Bat" + "nn."

Troubleshooting Guide

SYSTEM (including Wireless)
POSSIBLE CAUSE
1a. Transmitter or 5881 not properly powered.
1b. If Transmitter is 5827/5827BD, House ID
code not set in field 24, or transmitter not
*
set to same House code set in that field.
1c. Transmitter located too far from 5881.
1d. Metal shielding between transmitter and
5881.
1e. Transmitter malfunctioning.
1f. 5881 malfunctioning.
1g. Transmitter No. (zone) not programmed.
1h. 5881 address incorrect.
1i. Field 22 not properly programmed.
2a. Transmitter zone type (ZT) is set to 00
(Not Used).
2b. Transmitter battery not installed.
2c. 5800 System transmitter serial no. not
entered in system.
3a. System battery is low or missing.
3b. Remote RF wireless keypad battery low.
3c. Transmitter in zone "nn" has a low battery.
S E C T I O N
Smoke Detectors
REMEDY
1a. Check or change transmitter's battery.
Check the control's mains power.
1b. Check code switches inside transmitter.
Must match
programmed in control.
1c. Move transmitter or 5881.
1d. Check for large metal obstructions, then
relocate transmitter if necessary.
1e. Verify by activating 5881 with another,
similar transmitter. If O.K. now, return
defective transmitter.
1f. Verify by making sure other transmitters
cannot activate 5881. If defective, replace
and return original 5881.
1g. Verify programming.
1h. Set DIP switch for address "0."
1i. Set field 22 to "2" for 5881 RF receiver.
2a. Set ZT to a valid active zone type in field
56.
*
2b. Install proper battery.
2c. Enter unit's serial no. in field
3a. Replace battery in control box.
3b. Replace battery in wireless keypad.
3c. Replace transmitter battery in zone "nn."
1 6
with RF House code
56 or 83.
* *
16-1