System Operation; Security Codes - ADEMCO Vista-10SEa Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section

Security Codes

Keypad Functions
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Security Codes
Installer Code
The installer programs the 4-digit Installer code initially as part of the programming
procedure. The factory default Installer code is "4-1-1-1," but may be changed in field 20.
NOTE: The Installer code is defined as User No. 1.
The Installer code is the only code that can allow reentry into Programming mode. In normal
operation mode, only the Master code can be used to enter the User codes (refer to "Assigning
the Master Code").
See the MECHANICS OF PROGRAMMING section in the separate Programming Guide
for details on exiting the Programming mode via 98 or 99.
Assigning the Master Code
In normal operation mode, assign the 4-digit Master code as follows:
Installer code + 8 + 2 + 4-digit Master code
NOTE: The Master code is defined as User No. 2.
Changing the Master Code
In normal operation mode, you can change the Master code by entering:
Master code + 8 + 2 + new Master code + new Master code again
User Codes
In normal operation mode, you can use the Master security code to assign up to 4* secondary
users 4-digit security codes (Users 3–6). It can also be used to remove Secondary User codes
from the system (individually).
*If a Duress code (User No. 8) is not assigned, up to 5 Secondary User codes (Users 3–8) will be available for
assignment.
To assign (or change) a Secondary security code, enter:
Master code + [8] + User # (3–6**) + desired 4-digit User
**User No. 8 is reserved for a Duress code. However, if a Duress code is not assigned, a Security code can be
assigned to an additional user (who will be User No. 8).
The system will emit a single beep when each Secondary User code has been successfully
entered.
To delete a Secondary security code, enter:
Master code + [8] + User #
S E C T I O N

System Operation

Trouble Conditions
1 5
15-1