Auxiliary Power Output; Programming - ADEMCO Vista-10SEa Installation And Setup Manual

•
Uses current-limiting circuitry for protection.
•
Optionally supervised against wire open and short circuits with trouble sounding,
display, and reporting.

Auxiliary Power Output

•
Provides 12VDC, 500mA maximum. Uses current-limiting circuitry for protection.
•
This output interrupts for smoke detector reset if 4-wire smoke detectors are used on
basic wired zone 5 (if zone 5 is programmed for Fire).

Programming

•
Programmed options are stored in electrically erasable, nonvolatile EEROM memory
(information can be reprogrammed at any time and will not be lost in the event of a
power loss).
•
The system can be uploaded, downloaded, or controlled via an IBM compatible computer
using ADEMCO's Compass Windows downloading software and a Hayes-compatible
modem specified by ADEMCO.
Keypad programming consists of:
• Data field programming.
• Interactive (menu) mode programming.
For programming from a keypad, a 6139 2-line alpha keypad must be connected (but need not
stay in the system).
Communication Formats Supported
• ADEMCO Contact ID.
• Audio format.
Zone Descriptors
•
You can assign alpha descriptors to all zones (useful only when using alpha keypads
and/or the 4285/4286 Phone Module).
AC Mains Power Supply
•
Uses 230VAC plugpack, Model XF1, with 16.5VAC, 25VA output.
Backup Battery
•
Rechargeable sealed lead acid 12VDC, 6.5AH.
Section 1: General Description
1-3