Adding Custom Words - ADEMCO Vista-10SEa Installation And Setup Manual

ZN 01
DOOR
Flashing Cursor if "6" is
pressed (system ready for
next word).
ZN 01
DOOR
Pr ogr am Alpha ?
0 = No, 1 = Yes
Alpha Pgm
Adding Custom Words (will not be annunciated by 4285/4286 Phone Module)
You can add up to five installer-defined words to the built-in alpha vocabulary. Each of the
five "words" can actually consist of a "word string" of one or more words, but no more than
ten characters can be used for each word or word string.
1. Perform steps 1, 2, and 3 of "Programming the Descriptors."
Select Custom Word mode (enter 1) when the prompt "Custom Words?" is displayed.
2. Enter the number (1–5) of the custom word or word string to be created. For example, if
you are creating the first custom word or word-string, enter 1; for the second, enter 2; etc.
A cursor will now appear at the beginning of the second line.
You can now enter the custom word's characters. Refer to the "Character (ASCII) Chart"
(on a following page) of letters, numbers, and symbols for the desired character and its 2-
digit number.
3. Press [#], followed by the 2-digit entry for the first letter you would like to display (e.g.,
65 for "A").
4. When you have entered the 2-digit number, press 6 to select it. The cursor will then move
9.
BACK
−
10. The two words in our example have now been
BACK
11. To enter a descriptor for the next zone, press [ ] plus
12. To exit the Alpha Descriptor mode, press
13. Press 0.
82
14. Press 99 to exit the Programming mode.
When adding custom words in steps 3–6, the keypad's keys
perform the following functions:
[4] Moves cursor one space to left.
[6] Selects desired letter; moves cursor one space to right.
[8] Saves the new word in the system's memory.
Section 11: Alpha Descriptor Programming
Press 6 to accept the selected word.
NOTE: If these are the only words you are using for
the descriptor, press 8 instead of 6 to save
them in memory.
entered.
Note, however, that up to three words may be entered
(provided the number of characters will fit on the
screen). Press 8 to save all words in memory.
The flashing cursor will disappear, indicating that the
word(s) are stored in memory for that zone, as shown
in the display at the left.
the desired zone number (e.g.,
display that followed step 4 will appear.
Now repeat steps 6 through 10 for the descriptor for the
next zone.
summary display.
The "Program Alpha?" prompt will be displayed.
The display at left will appear.
02). The summary
00 at the
11-3