Smoke Detectors - ADEMCO Vista-10SEa Installation And Setup Manual

SYMPTOM
4. VISTA-10SEa doesn't
respond to keystrokes on
keypad.
SYMPTOM
1. Detector alarms, no
apparent reason.
2. Detector's siren sounds.
POSSIBLE CAUSE
4a. "CC" or "MODEM COMM" displayed.
4b. "d1" or "BUSY–STANDBY" is displayed.
4c. "E4" or "E8" displayed.
Keypad address setting incorrect.
4d.
S M O K E D E T E C T O R S
POSSIBLE CAUSE
1a. Dust, dirt in sensing chamber.
1b. Improper location.
1c. Unit malfunctioning.
2a. Unit not receiving required power.
2b. Unit malfunctioning.
Section 16: Troubleshooting Guide
REMEDY
4a. System is in communication with down-
loader at central station. Wait until down-
load session is finished.
4b. System has just been powered and is in
its one-minute initialisation. To bypass this
time, press [#] + 0.
4c. More zones have been programmed than
the zone expansion modules can handle.
Delete some zones or use a higher-
capability RF receiver.
4d. Keypads must be set for address 31
(Nonaddressable mode).
REMEDY
1a. Clean unit's sensing chamber with vacuum
cleaner per unit's instructions.
1b. See unit's instructions for locations to
avoid. Relocate as necessary.
1c. Replace detector.
2a. Check for proper installation of battery. Try
new battery.
2b. Replace detector.
16-3