Installing Control And Rf Receiver Circuit Boards Together In The Cabinet - ADEMCO Vista-10SEa Installation And Setup Manual

VISTA-10SEa Installation and Setup Guide
Installing the Control's Circuit Board Alone or with a 4204, 4219 or 4229 Relay Unit
Installing the Control's Circuit Board in the Cabinet
1. Hang two white mounting clips (provided) on the raised cabinet tabs (see Detail B in
Figure 2-2).
2. Insert the top of the circuit board into the slots at the top of the cabinet. Make sure that
the board rests on the correct row (see Detail A in Figure 2-2).
3. Swing the base of the board into the mounting clips and secure the board to the cabinet
with the accompanying screws (see Detail B in Figure 2-2).
4. Plug the provided small telephone transformer module into the 2 connectors on the right
side of the control board, component side inward (against the main board).
Installing the 4204, 4219 or 4229 Module in the Cabinet
Any one of these units can be mounted in the cabinet with the main control board, if used.
See Figure 2-2.
1. Insert self-tapping screws (provided) in two adjacent raised cabinet tabs. Leave the heads
projecting 3mm.
2. Hang the unit on the screw heads via two of the slotted holes at the rear of its housing, as
shown in Figure 2-2.
3. The 4204's cover can be left off if the unit's DIP switch is set with its position 1 "ON" (to
the right) as shown in its instructions. The 4219's or 4229's cover can be left off if the
cover tamper jumper is placed in its upper (not tampered) position (see Detail C).
The tamper-protected cover is necessary for installations outside of the control's cabinet.
DETAIL B
SIDE VIEW OF SHORT
MOUNTING CLIPS
Figure 2–2. Installing the PC Board in the Cabinet Alone or (if used) with a 4204, 4219, or 4229
Installing the Control and RF Receiver Circuit Boards Together in the Cabinet
1. Hang two short (black) mounting clips (provided with receiver) on the raised cabinet tabs,
as shown in Detail B in Figure 2-3.
2. Insert the top of the receiver board (removed from its own case as described in its
2-2
CIRCUIT
BOARD
CABINET
DETAIL A
SIDE VIEW OF
CONTROL
BOARD SUPPORTING SLOTS
CIRCUIT
BOARD
DETAIL C
PLUGIN BOARD