Sequential Mode (For 5800 Series Wireless Transmitters); Two Methods Of Enrolling Transmitters; Using The Program Tool; Enrolling Transmitters Sequentially - ADEMCO Vista-10SEa Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section

Two Methods of Enrolling Transmitters

Using the Program Tool

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
been programmed, including transmitter loop numbers.)
Two Methods of Enrolling Transmitters
There are two ways to enroll transmitters. You can enroll each transmitter into the system as
you are entering the zone information in field 56 (the procedure is detailed in Section 6:
WIRELESS (RF) ZONE EXPANSION); or you can enroll all the transmitters in 83 Menu
mode after all other zone information has been entered in field 56. The enrolling method in
83 is called "sequential enrolling" and is described in this section.
Using the Program Tool
As an option, the new sequential mode allows you to use a 5804 button-type transmitter
as a "program tool." The advantage of using a program tool is that it enables remote
enrollment. You can move to the physical location of the transmitter to be enrolled, press the
upper left-hand button of the program tool, and then trip the intended transmitter (see step
10 for operation). The transmitter that you use as the program tool can also be used as a
transmitter in the system. If you plan to use an existing transmitter, you must first enroll it
into the system as its associated zones. You may then program it as the tool.
An alpha keypad is required for the following procedures.

Enrolling Transmitters Sequentially

To enroll transmitters sequentially, after all other zone information has been programmed,
do the following:
1. Enter Programming mode [Installer Code] + 8 + 0 on an alpha keypad. Enter the Serial
Number Sequential mode by pressing 83. The following prompt will be displayed.
Program Tool?
0 = No, 1 = Yes
00 Input S/N:
Ax x x-x x x x
(for 5800 Series Wireless Transmitters)
(Use this mode only after all other zone information has
0
L
Sequential Mode
Enrolling Transmitters Sequentially
2. If you are using a program tool, enter 1. If not, enter 0.
If a tool has already been programmed, this prompt will
not appear. If you are not using a tool or one has
already been programmed, skip to step 4.
3. If you entered 1, the system will prompt for the
transmitter's serial number. Enter the program tool's
serial number using one of the following methods:
a. Enter the 7-digit serial number printed on the
transmitter.
or
b. Press any button on the transmitter. The keypad will
beep twice and display the tool's serial number.
S E C T I O N 1 2
12-1