Panic Keys
There are three individual lettered keys (or Panic key pairs on some keypads) that, if
programmed, can be used to manually initiate alarms and send a report to the central
station.
You can program each individually for 24-hour Silent, Audible, Personal or Fire Emergency
responses. The Panic function is activated when the appropriate lettered key is pressed for at
least 2 seconds, or when both keys of the appropriate key pair are pressed at the same time.
See chart below.
The Panic functions are identified by the system as follows:
NOTES:
•
Keys [A], [B], [C] are not on all keypads.
•
Key [D], if present, does not perform a Panic function. See note below.
For the Silent Panic functions to be of practical value, the system must be connected to a central
station.
Disarmed, Not Ready..... Before arming, the system must be in the READY
Arming Away................... Enter code + AWAY [2].
Arming Stay ..................... Enter code + STAY [3].
Arming Instant................ Enter code + INSTANT [7].
Arming Maximum........... Enter code + MAXIMUM [4].
Quick Arming .................. (If enabled). Simply press [#] in place of the code,
Disarming......................... Enter code + OFF [1].
Bypassing Zones ............. Enter code + BYPASS [6] + zone number(s).
Chime Mode ..................... Enter code + CHIME [9].
Summary of Arming Modes Chart
Exit
Arming
Delay
Mode
AWAY
Yes
STAY
Yes
INSTANT
Yes
MAXIMUM
Yes
Panic Function Chart
Keys
Displayed as Zone
[1] & [ ], or [A]
[ ] & [#], or [B]
[3] & [#], or [C]
Section 15: System Operation
condition (all zones not on the exit route must be
intact). If the "NOT READY" message appears,
press the READY [ ] key to display faulted zones.
then
press
AWAY,
MAXIMUM to arm system as desired. Note that
the [#] key cannot be used in place of the code
when disarming the system.
To turn chime off, enter code + CHIME [9] again.
Features for Each Arming Mode
Entry
Perimeter
Delay
Yes
Yes
No
No
95
7
96
STAY,
INSTANT,
Interior
Armed
Armed
Yes
Yes
Yes
No
Yes
No
Yes
Yes
or
15-3