Ring Detection Count Chart - ADEMCO Vista-10SEa Installation And Setup Manual

Press 68 CANCEL REPORT CODE ENABLE
Press 69 RESTORE REPORT TIMING
Press 70 ALARM RESTORE REPORT CODE ENABLE
Press 71 TROUBLE RESTORE REPORT CODE ENABLE
Press 72 BYPASS RESTORE REPORT CODE ENABLE
Press 73 MAINS RESTORE REPORT CODE ENABLE
Press 74 LOW BATTERY RESTORE REPORT CODE ENABLE
Press 75 RF XMTR. LOW BATTERY RESTORE CODE ENABLE
Press
Press 92 NUMBER OF REPORTS IN ARMED PERIOD
Press 94 DOWNLOAD PHONE NUMBER
Press 95 RING DETECTION COUNT FOR DOWNLOADING
If you are using ...and if you are
This is sent upon disarming of the system after an alarm
condition was reported.
This option is used to select the desired occurrence of Restore
reports.
This is sent when the zone that caused an alarm is restored to
its nonfaulted condition.
This is sent when a trouble in a zone is restored.
This is sent when a zone that has been bypassed is
unbypassed.
This is sent when mains power has been restored after a mains
power outage.
This is sent when a system low-battery condition is restored to
normal.
This is sent when a transmitter that previously sent in a low-
battery message has sent a message indicating it no longer has
a low-battery condition.
91 CUSTOM OPTION SELECTION
Enter one digit to represent one of the following:
0 = None selected
8 = Exit delay restart
Exit Delay Restart: Allows user to permit entry into the
protected premises by pressing [ ] while the system is armed
in the STAY or INSTANT mode (without having to disarm and
rearm the system) by an appropriate key press.
This option can be used to limit the number of messages
(Alarm and Alarm Restore reports) sent to the central station
in an armed period. "0" limits reports to a total of 10; "1" allows
an unlimited number of reports.
Enter up to 12 digits:
0–9, [#] + 11 for " , " [#] + 12 for "#," [#] + 13 for a pause. Do
not fill unused spaces. End field by entering [ ].
If you enter fewer than 12 digits, exit field by pressing [ ] and
next field number. To clear entries, press 94 .
Refer to the chart on the following page and program this field
accordingly.

Ring Detection Count Chart

...and if you
Section 13: System Communication
(Default is 0 )
13-5