Showing Metadata - Acopia Adaptive Resource Switch Cli Maintenance Manual

Showing Metadata

You can run only one nsck job (report or rebuild) at a time on a given namespace. Use
show nsck
sync Jobs" on page
CLI Maintenance Guide
You can use the
nsck report metadata-only
all files and directories in a namespace's managed volumes. A file's physical location
is its directory path including the IP address of the filer where it resides; for example,
192.168.25.21:/usr/local/bin. You can use this command to see the before-and-after
effects of namespace policy on the actual location of your files.
From priv-exec mode, use the
file locations for a namespace:
nsck namespace report metadata-only [path] [norecurse]
where:
namespace (1-30 characters) specifies a namespace on which to report. Use
the
show namespace
path (optional, 1-256 characters) narrows the scope of the report to a specific
virtual path in the namespace (for example, '/eng/share'). This must be a
managed volume or a path within a managed volume.
norecurse (optional) specifies to not recurse into subdirectories during the
report.
to monitor the progress of nsck jobs; see
5-2.
The report goes to a file, "metadata_only.id.rpt." The id is a unique number for every
nsck report. The CLI shows the report name after you invoke the command. Use
to see the file listing; use
reports
off to an external FTP site, use the
This report has five major sections:
Metadata Utilities: nsck and sync
command to show the physical locations of
nsck report metadata-only
command for a list of configured namespaces.
"Showing the Progress of nsck and
, , or to read the file. To save the report
show tail grep
command from priv-exec mode.
copy ... ftp
Showing Metadata
command to show physical
show
5-7