Acopia Adaptive Resource Switch Cli Maintenance Manual page 248

Troubleshooting Managed Volumes
Correcting Share-Import Errors
Table 8-1. Share Status Conditions (Continued)
Status Condition
Error: Proxy User does not map to
root user via NFS.
Error: Remove incomplete: found files
on share.
Error: Root Squash is Enabled
Error: RPC error during import scan.
Error: Share attributes incompatible
with volume attributes.
8-42
Description/Action
(multi-protocol) The proxy user is a Windows username and
password that the volume can use as its identity for share import
and for policy operations. In a multi-protocol (CIFS and NFS)
namespace, the proxy user on the Windows side must map to the
root user on the UNIX side.
You can select a new proxy user for the namespace with the
command. If necessary, map the proxy user to root at the filer
itself; the Site Planning Guide
mapping on common multi-protocol filers.
An administrator failed to remove the share with
because client-visible files are still present on the share. Use the
option to remove all of the file entries from
remove-file-entries
the volume; this produces a client-visible effect, so do this with
caution.
Alternatively, you can use
(NFS) This indicates that the ARX did not have proper
permissions to create files at the back-end filer.
Check your back-end filer configuration: the back-end share
should have no-root-squash set for all of the ARX's proxy IP
addresses. (On some filers, you accomplish this by mapping the
anonymous user to UID 0 (zero).) Use the
command to check the filer's permission settings. Use the
command to list all configured proxy IP
ip proxy-addresses
addresses.
(NFS) Persistent NFS errors from a back-end share caused the
import to fail. Check the NFS service at the back-end filer.
(CIFS) The CIFS attributes set for the volume (with
,
compressed-files named-streams
and/or
unicode-on-disk
share. Use the
show exports
CIFS attributes for the share.
has instructions for creating this
remove-share nomigrate
show exports
,
persistent-acls
) are not all supported at the back-end
command to check the supported
CLI Maintenance Guide
no share
.
show
, ,
sparse-files