Adjusting Logging Levels - Acopia Adaptive Resource Switch Cli Maintenance Manual

bstnA6k(cfg)# smtp
bstnA6k(cfg-smtp)# mail-server email1.wwmed.com
bstnA6k(cfg-smtp)# from admin@acopia.wwmed.com
bstnA6k(cfg-smtp)# exit
bstnA6k(cfg)# exit
bstnA6k# copy logs syslog smtp://juser@wwmed.com/arx_syslog
bstnA6k# ...

Adjusting Logging Levels

CLI Maintenance Guide
Use the following syntax to send the syslog file in an E-mail message:
copy logs syslog-file smtp://[e-mail-address/]file
where
e-mail-address (optional) identifies the recipient of the E-mail message (for
example, "myCoWorker@myco.com"). If you omit this, it defaults to the
E-mail recipient set with the cfg-smtp
separate this from the file name.
file is the chosen file name.
For example, the following command sequence sets up SMTP, exits from cfg mode to
priv-exec mode, then mails the "syslog" file to "juser@wwmed.com:"
Each log component has a logging level that determines the volume of logs that it
generates. You can set a different logging level for every log component, allowing
you to focus attention on a single component or a small group of them.
Troubleshooting Tools
Accessing the Syslog
command. Use a slash (/) to
to
6-27