Acopia Adaptive Resource Switch Cli Maintenance Manual page 184

Troubleshooting Network Connections
Testing Throughput with TTCP
bstnA6k# show ron route
Default Policy
--------------
Destination
--------------------------------------------------------------------------
prtlndA1k
prtlndA1kB
bstnA6k# expect ttcp transmit 169.254.54.1
Starting 10 second TCP transmit test. Hit ^C to abort...
586.5138 MB /
bstnA6k#
Waiting for TTCP client. Hit ^C to abort... <Ctrl-C>
prtlndA1k#
7-10
Go to the sending switch to run the test. The IP address to use for the server switch is
the .1 address on the server's private subnet. Use the
"Showing the RON Routes" on page 5-10
find the private subnet for the server switch. To continue the example, this command
sequence finds the private subnet for "prtlndA1k," then runs a TTCP test over the
RON tunnel:
Subnet
169.254.54.0/24
169.254.80.0/24
10.00 sec = 491.9229 Mbps 12 %TX 23 %RX
When the test is over, go back to the server switch and press <Ctrl-C>:
The server switch can only receive TTCP transmissions from another ARX on the
same RON.
show ron route
of the CLI Network-Management
via Tunnel
toPortland
toPortland
command (see
Guide) to
Milliseconds
0.1
0.1
CLI Maintenance Guide