Table of Contents
Advertisement
8 bytes from 10.53.2.10: icmp_seq=4 ttl=0 time=100 ms from 3.3
8 bytes from 10.53.2.10: icmp_seq=5 ttl=0 time=100 ms from 3.3
8 bytes from 10.53.2.10: icmp_seq=5 ttl=0 time=100 ms from 3.3
-------10.53.2.10 ping statistics
6 packets transmitted, 6 packets received, 0% packet loss
round-trip min/avg/max 1/1/3 ms
bstnA6k> ...
Sending an Alternate Source IP
CLI Maintenance Guide
You can use an alternate source-IP address in a ping. By default, the source IP is
calculated based on the originating processor's routing table.
There are three types of internal IP addresses that you can use as sources for ping:
proxy IPs, Virtual IPs, and management IPs.
•
The network processors use proxy-IP addresses to communicate with servers.
Use the
show ip proxy-addresses
page 4-7
of the
CLI Network-Management
Each network processor is assigned its own proxy-IP.
•
The network processors use virtual-IP (VIP) addresses to communicate with
clients. Use the
show global server
on page 10-11
of the
•
There are two types of management interface: one in-band interface for each
VLAN and one out-of-band (OOB) management interface. Use the
command to list all VLAN-management interfaces (see
interface vlan
VLAN Management Interfaces" on page 4-6
Guide). Use
show interface mgmt
interface (see
"Showing the Interface Configuration" on page 4-22
Network-Management
If you set a source IP without setting the source processor, the source IP determines
the processor. For example, if you choose the IP for the out-of-band management
port, the CLI sends the ping from the SCM processor.
Troubleshooting Network Connections
command (see
command (see
CLI Storage-Management
to find the source address for the OOB Mgmt
Guide).
Pinging an IP Address
"Showing all Proxy IPs" on
Guide) to list all proxy-IP addresses.
"Showing All Global Servers"
Guide) to list all VIPs.
of the
CLI Network-Management
show
"Listing all
of the
CLI
7-5
Advertisement
Table of Contents
Troubleshooting
