Powering Down The Arx; Saving Configuration Parameters - Acopia Adaptive Resource Switch Cli Maintenance Manual

Saving Configuration Parameters

bstnA6k# copy running-config ftp://juser:jpasswd@172.16.100.183//var/a6k-running.cfg
% INFO: The copy command completed successfully.
bstnA6k# copy global-config ftp://juser:jpasswd@172.16.100.183//var/a6k-global.cfg
% INFO: The copy command completed successfully.
bstnA6k# ...
CLI Maintenance Guide
You can power down the ARX for up to 72 hours without incurring significant down
time on power-up. This chapter describes how to power down a single ARX and a
redundant pair of them. For down times of greater than 72 hours, contact Acopia
support.
Save a copy of the ARX configuration. The configuration parameters are divided into
two classes: running-config and global-config. The running-config has all of the
chassis, network, and redundancy parameters; all of the CLI commands for
running-config are under "cfg" mode. The global-config contains all namespaces,
volumes, global servers, policy rules, and other storage parameters. The CLI
commands for global-config are under "gbl" mode. Save a copy of both the
running-config and the global-config. An earlier chapter described all of this: recall
"Backing Up the Running Configuration" on page
Use the
copy running-config
the switch. For example, the following command sequence copies the running-config
and global-config off of the "bstnA6k" switch to a remote FTP server:

Powering Down the ARX

and
copy global-config
Chapter 11
3-1.
commands to copy the files off of
11-1