Running The Restore From A Remote Host - Acopia Adaptive Resource Switch Cli Maintenance Manual

Backing Up a Volume's Files
Restoring Files
[OK DE NC] [
[OK FE NC] [
[OK FE NC] [
[OK FE NC] [
[OK FE ] [
[OK FE NC] [
**** Total Found Items:
**** Total Transferred Items:
**** Total Failures:
**** Total Bytes Restored:
**** Total processed:
**** Elapsed time:
**** Restore Data Report: DONE at Thu Jan 19 05:35:32 2006 ****
bstnA6k# ...

Running the Restore from a Remote Host

2-8
] /stats/in_home:2005
249,856] /stats/in_home:2005/age:11-21yrs.csv
162,816] /stats/in_home:2005/age:<10yrs.csv
216,064] /stats/in_home:2005/age:>21yrs.csv
6,365] /stats/carrierCrossCheck.html
305,152] /stats/PieChart.ppt
14
00:00:02
From any remote host that supports the Secure SHell (SSH) protocol, you can run the
command and see the report. Use the following syntax with ssh:
restore data
ssh admin-user@mip "restore data..."
where
admin-user is the username for a valid administrative account at the ARX
(use
show users
Users" on page 2-14
mip is a management-IP address for the ARX (use
show the out-of-band management interface, or
all in-band management interfaces), and
restore data... is the full
this with quotation marks ("").
The output of the CLI command appears in the local shell. This also works with all
commands.
show
For example, the following command sequence re-runs the above
command from a remote machine, "mgmt17."
14
14
0
1,694,056
to list all of them, as shown in
of the CLI Network-Management
command, described above. Surround
restore data
"Listing All Administrative
Guide),
show interface mgmt
to show
show interface vlan
restore data
CLI Maintenance Guide
to