Acopia Adaptive Resource Switch Cli Maintenance Manual page 242

Troubleshooting Managed Volumes
Correcting Share-Import Errors
Table 8-1. Share Status Conditions (Continued)
Status Condition
Error: Filer does not support specified
protocols.
Error: Filer error during import.
Error: Filer generated name collision
is not supported by filer.
Error: Hard link counts inconsistent
with physical files.
Error: Hard Links Inconsistent
Error: Hard Links Not Supported
Error: Hard links not supported on
CIFS.
8-36
Description/Action
The protocol(s) configured for the back-end share are not
actually supported at the filer. Use the
check the protocols supported by the filer. Use the
global-config namespace
protocols for the namespace. The share must support all of the
namespace's protocols.
This may indicate a disk failure at the external filer. Correct the
filer issue and retry the import.
(multi-protocol) The share contains an entry whose
filer-generated name (FGN) matches a real name in an
already-imported share, or whose real name conflicts with an
already-imported FGN. The volume is backed by a mix of
BlueARC filers and filers from other vendors, and this naming
conflict is not supported for this vendor combination.
The import report shows the name of the conflicting file or
directory. The name appears with an "FC" notation. The report is
named "import.job-id.share-name.share-id.rpt." Use
to list all import reports and read their contents.
reports
Using the import report, resolve all of these name collisions
before re-importing. Go to the filer to rename the files and/or
directories. Then re-import the share.
(NFS) One or more files in the exported directory have hard
links from outside the directory. That is, the switch tried to
import a hard link to file X but detected that there was at least
one more hard link to file X in some other directory, not
included in the NFS export.
Remove the hard links from the external directories and retry the
share import.
(CIFS) Hard-links exist in a CIFS share (not supported in CIFS
by the ARX).
show exports
command to view the required
CLI Maintenance Guide
command to
show
show