Sending The Config To An E-Mail Recipient; Prepared For Disaster Recovery - Acopia Adaptive Resource Switch Cli Maintenance Manual

Backing Up the Running Configuration

Prepared for Disaster Recovery

Sending the Config to an E-Mail Recipient

bstnA6k(cfg)# smtp
bstnA6k(cfg-smtp)# mail-server email1.wwmed.com
bstnA6k(cfg-smtp)# from admin@acopia.wwmed.com
bstnA6k(cfg-smtp)# to juser@wwmed.com
bstnA6k(cfg-smtp)# exit
bstnA6k(cfg)# exit
bstnA6k# copy startup-config smtp://feb6startup
bstnA6k# ...
Prepared for Disaster Recovery
3-18
You can alternatively send the startup-config file as an E-mail attachment, as shown
above for the global-config and running-config. Before you use E-mail, you must
configure the Simple Mail Transfer Protocol (SMTP) on the switch, starting with the
command in cfg mode: see the chapter on E-mail and SMTP in the
smtp
Reference Guide.
Use the following syntax to send the startup-config file in an E-mail message:
copy startup-config smtp://[e-mail-address/]file
where the options were defined for mailing the running-config (recall
the Config to an E-Mail Recipient" on page
For example, the following command sequence sets up SMTP (including a
destination E-mail address, "juser@wwmed.com"), exits from cfg mode to priv-exec
mode, then mails the startup-config file:
Once you have saved both the local and global running-configs (or the single
startup-config), the ARX is prepared for disaster-recovery.
3-4).
CLI Maintenance Guide
CLI
"Sending