Copying A Release File To The Switch - Acopia Adaptive Resource Switch Cli Maintenance Manual

Copying a Release File to the Switch

bstnA6k# copy ftp://jusr:jpasswd@ftp.acopia.com/mainline.9308.rel releases test5.rel
% INFO: Copying 328 megabytes from the specified source . . .
% INFO: Transferred 190886 of 335963 kbytes; still copying . . .
% INFO: The copy command completed successfully.
bstnA6k# show releases
releases
B test2.rel
R A test3.rel
CLI Maintenance Guide
The next step in upgrading software is to copy the new release file to the switch. From
priv-exec mode, use the
releases directory:
copy ftp://[username:password@]ftp-site/file releases dest-file
where
username:password@ (optional) is an FTP username and password (the
default is the username/password set by the
"Setting a Default FTP User" on page
ftp-site identifies the FTP server with an IP address or FQDN (for example,
"172.16.88.3" or "ftp.myftpsite.com"),
file is the chosen file name (lead with two slashes (ftp-site//file) if the file
path is absolute),
releases is the directory, and
dest-file is the local-release-file name.
For example, the following command sequence copies a release file from
ftp.acopia.com, then uses
May 20 07:55
May 20 10:33
Copying a Release File to the Switch
command to copy a release file from an FTP site to the
copy
to confirm that the file was copied:
show releases
456M
456M
Upgrading Software
command; see
ip ftp-user
3-1),
4-5