Restarting The Import - Acopia Adaptive Resource Switch Cli Maintenance Manual

Table 8-1. Share Status Conditions (Continued)
Status Condition
Import Interrupted
Internal Error (number)
Metadata Only
Offline: Volume Disabled
Offline: Volume Failed
Remove Interrupted
Storage job aborted.
Uninitialized (No filer assigned)

Restarting the Import

CLI Maintenance Guide
An administrator stopped the import with the
command. You may be able to restart the import with
(gbl-ns-vol-shr)
far in the process, you must first use
down the volume, remove and re-add the share, then
volume again.
nternal problem; contact Acopia personnel.
I
The share is designated to store namespace metadata only, so
there are no client-accessible files to import. This serves as an
explanation; it is not an import error.
No imports are possible unless the volume is enabled. Use the
enable (gbl-ns, gbl-ns-vol)
The metadata share for the volume failed to import. Use
metadata share
or use
An administrator stopped the share removal with the
remove
remove-share migrate
filer
The import process was interrupted by an
Use the
import.
After you correct the problem, you can restart the import for the share. To remove the
share from the managed volume, skip ahead to the next section.
Troubleshooting Managed Volumes
Description/Action
and then
enable
to designate a new dedicated share for metadata,
to allow metadata on an imported share.
metadata allowed
command. To restart the removal process, use
,
remove-share nomigrate
.
command to assign a filer to the share, then retry the
filer
Correcting Share-Import Errors
cancel import
. If the import was stopped too
nsck ... destage
command to enable the volume.
,
no
nsck ... rebuild
no enable
to shut
the
enable
cancel
, or
share no
.
force
8-45