Restoring Configs To A Redundant Pair - Acopia Adaptive Resource Switch Cli Maintenance Manual

Restoring Configs to a Redundant Pair

Do not restore the same running-config to both peers. The running-config includes the
switch's private subnet, which must be unique to both peers. In fact, the private subnet
must be unique in the switch's entire RON; see
page 5-12
CLI Maintenance Guide
The CLI commands run on the command line until the configuration is finished.
For example, the following command sequence enters priv-exec mode, shows the
saved scripts, and runs the "start_conf" script (which contains both the running and
global configs):
SWITCH> enable
SWITCH# show scripts
scripts
global
running
start_conf
SWITCH# run scripts start_conf
SWITCH# config
SWITCH(cfg)# hostname bstnA6k
bstnA6k(cfg)# ...
bstnA6k(gbl)# exit
bstnA6k# ...
We recommend a two-phased approach for restoring configs to a redundant pair:
restore the running-config to each switch, then restore the global-config on either
switch. This synchronizes the pair before starting any namespace imports. Other
orders are possible, but this is considered best practice.
of the CLI Network-Management
Backing Up the Running Configuration
Restoring the Configuration
Mar 16 01:59 6.5k
Mar 16 01:59 3.0k
Mar 16 01:59 9.6k
"Resolving Conflicting Subnets" on
Guide.
3-21